[Unit]
 Description=Re-apply the cce Power page's plan after waking
 Documentation=file:/etc/cce/power.kdl
 # The kernel's Mains change event is not a reliable record of a charger
 # plugged or pulled while the machine slept. Some firmware sends none, and
 # one that lands during the thaw merges into a cce-power-apply.service run
 # that sleep froze, which then applies what it read before sleeping. That
 # happened on 2026-10-02: the machine woke on AC in the battery mode, with
 # animations off. Each sleep target is reached only once the machine is
 # awake again, so ordering after them is "on resume".
 #
 # This runs the applier directly, not by starting cce-power-apply.service,
 # because the start would merge into that same frozen run. Two runs at once
 # are harmless: each reads the source again when it finishes.
 #
 # Wanted by the sleep targets, so unlike the udev-started unit this one does
 # nothing until it is enabled. X-CceEnable tells `ccebuild install-system`
 # to enable it (systemd ignores X- keys).
 After=suspend.target hibernate.target hybrid-sleep.target suspend-then-hibernate.target
 ConditionPathExists=/etc/cce/power.kdl
 
 [Service]
 Type=oneshot
 ExecStart=/usr/bin/cce-power-apply apply
 
 [Install]
 WantedBy=suspend.target hibernate.target hybrid-sleep.target suspend-then-hibernate.target
 X-CceEnable=yes